THC Vape label law: guide

Quality control, in plain terms

Buyers come to us for THC vape after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for private label sellers.

11 separate checks run before a carton is sealed: electrical, mechanical, leak, finish and packaging. Anything outside tolerance is quarantined the same day and reported to you, rather than shipped with a hope and a discount.

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

What happens when something goes wrong

Every account gets a named contact who has actually seen the product. Being passed between three people to answer one question about a coil resistance is the fastest way to lose a buyer, so we do not organise support that way.

For private label accounts we hold the artwork files and the approval record. Rebranding a line eighteen months later is then a file update instead of a redesign.

Assortment planning without the guesswork

The first question we ask is not what you want to spend. It is what your customer already buys. Answer that and the THC vape list writes itself; skip it and you end up with a pallet of stock that photographs well and sells badly.

We keep a short list of approved configurations for THC vape products. Anything outside that list is possible, but it becomes a custom run with a custom lead time, and we quote it as such rather than pretending everything is standard.

• Standing reorder schedule with a fixed cut-off
• Document pack prepared per destination market
• Private label files archived for future rebrands
• Cartons drop-tested and pallet-counted for clean freight
• Named account contact who has handled the product
• Seven-day defect reporting with replace-or-credit

Transit, consolidation and timing

For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.

We ship from Shenzhen and Guangzhou: air express for samples and part loads, sea freight for volume. Typical production lead time is 30 working days after artwork approval, plus transit. We quote both routes so you can see the trade-off instead of guessing at it.

Specification summary

The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz